This error occurs when you don't have a valid filename for the file being saved. Occurs when trying to save a data file using the Factory Software. Close ALL unrelated software and try again.

This can also occur if other software is running on your PC that may be loading down the CPU.

Your cable is not plugged in all the way.

(tune to a quiet channel or remove antenna.)

You are receiving a signal while trying to connect.

Your radio is not turned ON when trying to program.

BFB290 and_prior, and BFB291_and_later require different software.

(UV-5R) Incorrect software version for your firmware release.

This message is generated by the Factory Software. Fail Connect with Transceiver (UV5R / UV82 series) ¶

You must upgrade to CHIRP's Latest Daily Build. These messages are generated if you are running a much older version of CHIRP.

Failed to communicate with radio: global name 'vendors' is not defined.

CHIRP does not support my (Model Radio).

You need to Downgrade to v3.2.0.0 Support errors ¶ ¶ Cannot Start (Code 10) in Windows 8 ¶Įrror occurs if Prolific driver version is higher than v3.2.0.0 Run-time error 8020: Error reading from comm device. Changing your USB slot will change the com port number.Īfter making this change, you must unplug and replug your USB programming cable for the new com port number to be effective. Here is a Graphic and Possible Solution Error has Occurred, Could not open Com Port x ¶Įach USB slot is connected to a separate com port to avoid conflict. The cable may still need to be trimmed, but from the cable tension area. The cable cannot seat properly, not because it is misaligned, but rather the ridge on the case may be protruding out too far. The GT3 and similar radios with optional case designs may require a slightly different approach to trimming the cable. A slight trimming of the cable's plug side and edge may be required. One indication is that the transmitter may be keyed.

Some cables require a really hard push to snap in that last 1/16 inch. Make sure the connector is snapped in all the way. Slightly offset audio jacks could be the problem. Radio Radio refused to enter Programming Mode.Go there for more detailed information Common Errors ¶ This information is a summarized version of the Miklor page on the subject. The UV-5R is the base model for a lot of variants, so this page will apply to many more people than just those with that specific badge on their radio. This page provides general tips and troubleshooting for the Baofeng UV-5R, UV-82, and related radios (See Baofeng_UV5R_Variants). Fail Connect with Transceiver (UV5R / UV82 series).Run-time error 8020: Error reading from comm device.Error has Occurred, Could not open Com Port x.

Uv 82 baofeng chirp programming